Guides/Assembly

Not sure how to assemble your footrest on your Antilop?
Or are the chair leg stickers a bit tricky? What are the metal clamps for? Here are some guides to help you out:

Chair Leg Stickers:

1. Remove the chair leg from the chair and turn it over.
2. Apply the sticker, starting at the foot end.
3. Smooth it down with your hand in long, even strokes.
4. Seal one side first, then the other.

👉 See the assembly video here

Footrest with Rubber Rings:

1. Assemble the chair legs.
2. Attach the rubber rings to the legs, two on each.
3. Place the footrest and adjust the rubber rings properly.

👉 See the assembly video here

Footrest with Rubber Rings + Metal Clamps:

Metal clamps are helpful when your baby gets stronger and the footrest tends to slide down.

1. Assemble the chair legs.
2. Attach the rubber rings to the legs, two on each leg.
3. Place the footrest and adjust the rubber rings—one above and one below.
4. Twist the metal clamp up and attach it beneath the lowest rubber ring on each chair leg. Tighten it. Done!

👉 See the assembly video here

These guides will make the assembly easy and smooth! 😊